|Name:||Halogen Rapid Moisture Meter||Set Time::||1 Minute Interval Between 0 And 99 Minutes|
|Humidity Display Mode::||Relative Humidity||Heating Temperature Range (℃):||60-200|
|Boot Preheat (min):||20-30||Overall Dimensions:||(length * Width * Height)(mm) 310*205*200|
fat analyzer machine,
food testing equipment
ST-100 halogen rapid moisture meter (1/10000)
The traditional moisture measurement method is usually oven drying method. The test of a sample needs two or three or even three or four hours, and the moisture value (moisture content) of the sample can be obtained by weighing and manual calculation through a balance.
The low efficiency of drying oven moisture measurement can not adapt to the high pace of enterprise production needs.
ST series rapid moisture meter is the latest high-efficiency moisture meter developed by me. It adopts high-efficiency drying heater -- high-quality ring halogen lamp to heat the sample rapidly and uniformly, and the moisture of the sample is continuously dried.
During the whole measurement process, the instrument fully automatic real-time display of measurement results: sample weight, water content, solid content, measurement time, heating temperature, etc.
ST series halogen rapid moisture meter applies the principle of international oven drying method, and the results are in good agreement with that of oven drying method, but its efficiency is much higher than that of oven drying method.
ST series electronic rapid moisture meter, the general sample only need a few minutes to complete the measurement, so by the majority of users favor and praise.
The instrument is widely used in industry, agriculture, medicine, scientific research institutions and other industries.
It can quickly test the free water content of tobacco, tablet, paper, food, tea, grain, chemical raw materials, pharmaceutical raw materials, plastic plastic raw materials, textile raw materials and other samples.
Range (g) : 100g-0.0001g
Weighing readability (g) : 100
Repeatability (standard deviation) >
When 2 g + / - 0.001%
10 g + / - 0.005%
Calibration method: temperature calibration, external weight calibration
Φ 90 scale size (mm)
Overall dimensions (length * width * height)(mm) 310*205*200
Boot preheat (min)20-30
Display LCD liquid crystal display
Heating temperature range (℃) 60-200
Drying procedure: standard heating, step heating, weightless heating
Humidity display mode: relative humidity
Stop mode: automatic stop, manual stop, timed stop
Set time: 1 minute interval between 0 and 99 minutes