|Range:||0.1%-100%||The Largest Weighing:||110g|
|Balance Readability:||5mg||Water Readability:||0.01%|
|Thermostat Range:||Room Temp -200 Degree||Drying Technology:||Halogen Heating|
|Output Interface:||RS232C||Said Plate Size:||85mm|
|Dimensions:||330x200x200 Mm||Key Words:||Feed Moisture Tester|
|Key Words:||Flour Moisture Tester|
chemical analysis equipment,
chemical analysis machine
ST-60 halogen moisture meter (no print)
ST series halogen rapid moisture meter applies the principle of international oven drying method, and the results are in good agreement with that of oven drying method, but its efficiency is much higher than that of oven drying method.
ST series electronic rapid moisture meter, the general sample only need a few minutes to complete the measurement, so by the majority of users favor and praise.
The instrument is widely used in industry, agriculture, medicine, scientific research institutions and other industries.
It can quickly test the free water content of tobacco, tablet, paper, food, tea, grain, chemical raw materials, pharmaceutical raw materials, plastic plastic raw materials, textile raw materials and other samples.
The characteristics of
1. It can be used without installation and debugging;
2, no training, simple operation, tedious use of steps;
3. Short measurement time and high work efficiency;
4. Uniform heating, stable performance and accurate testing;
5. Small size and light weight;
6. Automatic measurement, alarm and reminder after measurement, no need to watch the measurement process;
7, the use is very wide, almost applicable to the determination of moisture in all industries;
8. Sensors imported from Germany make instrument testing more excellent and accurate;
9. The unique windshield design makes the weighing system of the instrument more stable;
10. The water content and solid content of the sample can be converted simultaneously;
11. The heating chamber is made of pure stainless steel, which is resistant to high temperature and easy to clean.
The traditional moisture measurement method is usually oven drying method. The test of a sample needs two or three or even three or four hours, and the moisture value (moisture content) of the sample can be obtained by weighing and manual calculation through a balance.
The low efficiency of drying oven moisture measurement can not adapt to the high pace of enterprise production needs.
ST series rapid moisture tester is a high efficiency moisture measuring instrument developed. It adopts high efficiency drying heater - high quality ring halogen lamp to heat the sample quickly and uniformly. The moisture of the sample is continuously dried.
During the whole measurement process, the instrument fully automatic real-time display of measurement results: sample weight, water content, solid content, measurement time, heating temperature, etc.
The characteristics of Feature
Halogen light heating
Tainless steel chamber
Temperature and time can be set
The percentage is The percentage of moisture content
The percentage shows The percentage of dry residual
Large LCD with backlight
Multiple groups of drying process Store historical setting can be remembered
|The largest weighing||110g|
|Thermostat range||Room temperature -200℃|
|Drying Technology||halogen heating|
|Said plate size||85mm|
|Power||AC 220V 50Hz|