Home News

company news about Preparation of oil leakage proof parts in determination of sulfur content in heavy oil by X-ray method

Certification
China Shandong Shengtai instrument co.,ltd certification
I'm Online Chat Now
Company News
Preparation of oil leakage proof parts in determination of sulfur content in heavy oil by X-ray method
Latest company news about Preparation of oil leakage proof parts in determination of sulfur content in heavy oil by X-ray method

   

Preparation of oil leakage proof parts in determination of sulfur content in heavy oil by X-ray method

The determination of sulfur content in heavy oil adopts the principle of energy dispersion and the Microcomputer Design of mechatronics, so the analysis is fast and accurate. Its repeatability and reproducibility meet the relevant requirements of the national standards gb/t17040 and gb11140 and the petrochemical industry standard sh/t0742. The SH407 heavy oil X-ray sulfur content tester also fully meets the requirements of the more stringent American national standard astmd4294-02. It provides an important means for the detection of sulfur content in crude oil or petrochemical production. The instrument itself is green and environmentally friendly, and its price is only a fraction of that of imported instruments

latest company news about Preparation of oil leakage proof parts in determination of sulfur content in heavy oil by X-ray method  0

Preparation of oil leakage proof parts

The oil leakage prevention part is composed of inner ring, outer ring and polyester film, which is set to prevent the oil in the sample cup from leaking to the instrument probe. It is always used in the use of the instrument.

1. place the oil leakage proof steel inner ring in the large concave circle of the pressure seat, with the small round base of the inner ring facing upward, and then place the polyester film in the middle on the small round bottom of the inner ring, as shown in figure (a);

2. put the oil leakage proof outer ring sleeve on the inner ring with film, and press it slightly after placing it properly; See figure (b);

3. press the outer ring to the bottom with the gland, as shown in figure (c);

4. remove the gland, remove the oil leakage proof parts from the pressure seat, and observe the polyester film. If it is tight and flat, it meets the requirements. Cut off the excess polyester film of exposed parts for standby; See figure (d);

  latest company news about Preparation of oil leakage proof parts in determination of sulfur content in heavy oil by X-ray method  1

Pub Time : 2022-06-29 17:36:05 >> News list
Contact Details
Shandong Shengtai instrument co.,ltd

Contact Person: Miss.

Send your inquiry directly to us (0 / 3000)