Home News

company news about Low temperature kinematic viscosity measurement solution for motor vehicle brake fluid

Certification
China Shandong Shengtai instrument co.,ltd certification
I'm Online Chat Now
Company News
Low temperature kinematic viscosity measurement solution for motor vehicle brake fluid

The brake fluid is the liquid medium to transfer the brake pressure in the hydraulic braking system, which is used in the vehicles using the hydraulic braking system.
Brake Fluid, also known as Brake Fluid or force oil, is an indispensable part of the Brake system. In the Brake system, Brake Fluid is used as a medium for force transmission. Because the liquid cannot be compressed, the pressure output from the main pump is directly transferred to the sub-pump through the Brake Fluid.
SH112F automatic low-temperature petroleum kinematic viscometer this instrument conforms to the national standard GB/T265 "Petroleum Products kinematic viscosity measurement method and dynamic viscosity calculation method" standard and NB/SH/T0837 mineral insulating oil low-temperature kinematic viscosity measurement requirements.
Can be placed at the same time 2 viscosity and experiment, can be measured -20 degree viscosity, also can be measured 20 degree viscosity, suggested that the medium can choose antifreeze.
Automatic sample injection, automatic cleaning, automatic detection, automatic output, automatic printing.
Apparatus needed for experiment
1.SH112F automatic low-temperature kinematic viscometer, developed and produced by Shandong Shengtai Instrument Co., LTD.
2. GB/T265 viscosity tube.

Experimental steps:
Preparation work
1. After unpacking the instrument, please count the accessories according to the packing list. If there is any damage, please contact our company.
2. The instrument should be handled vertically. The tilt Angle should not exceed 30 degrees along the height of the instrument.
3. Connect the power supply of the instrument to the socket with a capacity of 220V/10A or above, and pay attention to having a good grounding wire.
Ii. Experiment process
According to different interfaces, the functions of the instrument are described as follows:
1. Start the machine and display the instrument name. After 2 seconds, it will automatically enter the test interface.

2. Test interface:

As shown in the figure above, there are two buttons "Main interface", "Parameter Setting", "System Setting" and "Historical data" above the interface.
When the constant temperature bath is equal to the set temperature, click "Start" to start the timer. When the set time is reached, the timer will automatically stop, and the buzzer will alarm for 3 seconds. The display will display "End of the constant temperature, start the test", and you can click "No. 1 'No. 2" to start the timing test.
Press the "Stop" button to terminate the test without saving the test results.

Pub Time : 2020-11-09 14:39:57 >> News list
Contact Details
Shandong Shengtai instrument co.,ltd

Contact Person: Miss.

Send your inquiry directly to us (0 / 3000)