Low temperature kinematic viscosity measurement solution for motor vehicle brake fluid

January 5, 2022
Latest company news about Low temperature kinematic viscosity measurement solution for motor vehicle brake fluid

Low temperature kinematic viscosity measurement solution for motor vehicle brake fluid

 

latest company news about Low temperature kinematic viscosity measurement solution for motor vehicle brake fluid  0

 

Brake fluid is a liquid medium used to transfer brake pressure in hydraulic brake system, which is used in vehicles using hydraulic brake system. Brake Fluid, also known as Brake Fluid or forced oil, is an indispensable part of the braking system, and in the braking system, it is as a force transmission medium, because the liquid can not be compressed, so the pressure output from the master pump will be directly transmitted to the sub-pump through the Brake Fluid.
SH112F Fully automatic low temperature petroleum kinematic viscometer The instrument conforms to the national standard GB/T265 "petroleum products kinematic viscosity determination and dynamic viscosity Calculation method" standard and NB/SH/T0837 mineral insulating oil low temperature kinematic viscosity measurement requirements. 2 viscosity can be placed at the same time and experiment, can measure the viscosity of -20 degrees, also can measure the viscosity of 20 degrees, it is suggested that the medium can choose antifreeze. Automatic sampling, automatic cleaning, automatic detection, automatic results, automatic printing.


Instrument for experiment
1.SH112F automatic low-temperature kinematic viscometer, developed and produced by Shandong Shengtai Instrument Co., LTD.
2. Comply with GB/T265 viscosity tube.

Experimental steps:
First, preparation
1. After unpacking the instrument, please check the accessories according to the packing list. If there is any damage, please contact our company.
2, the instrument should be carried vertically, tilt Angle along the height of the instrument swing Angle is not more than 30 degrees, placed in the dark place, place to be stable, otherwise there will be vibration after the instrument starts, affecting the service life of the instrument.
3, the instrument power supply is received in the capacity of 220V/10A above the socket, pay attention to must have a good grounding wire.